02 / IndustriesStudio model, not a job

Technical and energy enclosures

A container or a steel housing built around equipment that someone else supplies: battery racks, a generator, switchgear, a pump or a compressor. The equipment sets the limits; the drawing makes the steel fit around it and leaves room to service it.

01 / 03

What is drawn for an enclosure

The arrangement of the enclosure with the equipment shown as the outline the client supplies: where it stands, how it is fixed, and the clear space in front of every door and panel that has to open.

The frame or the floor structure under the equipment, openings for ventilation, cable entries and service doors with their trim, and the lifting and fixing points the brief asks for.

Drag sideways to turn the model

  1. Corner post and rail frameStudio model, not a job
  2. Long wallStudio model, not a job
  3. End walls and far wallStudio model, not a job
  4. RoofStudio model, not a job
  5. Trim around the openingStudio model, not a job

02 / 03

Which files come out of it

A PDF of the arrangement with the equipment outline, so its supplier can check the fit. A DXF at 1:1 for the cut-outs and plates. A STEP file of the enclosure when the equipment supplier or an integrator models the inside. The reply confirms the list.

03 / 03

What this page does not promise

This page does not promise an electrical design, a cooling or ventilation calculation, a fire or explosion rating, or a certificate for the enclosure. Weights and footprints come from the equipment supplier; the drawing does not guess them. If a structural check of the frame is part of the job, the reply says so.

Quote

Drawn for your job, not for a sector.

The sector only sets the questions. Describe your object, its limits and the files you have, and the reply names what will be drawn, in which files, and what is not in the job.

What matters hereTechnical and energy enclosures

What a set for this sector has to resolve.

The questions a drawing set in this sector usually has to answer before anything is cut. The enquiry does not need every answer; the reply asks for what is missing.

  1. 01

    The equipment sets the limits

    Footprint, weight, fixing points and outline come from the equipment supplier, as a model or a drawing. The enclosure is drawn around that data, not around a guess.

  2. 02

    Room to service it

    Doors and removable panels sit where the equipment is serviced, and the clear space in front of them is drawn on the plan.

  3. 03

    Openings for air and cables

    Louvres, fans and cable entries cut the walls and the floor. Their position, their trim and what closes them are fixed on the drawing before the steel is cut.

  4. 04

    Lifting with the equipment inside

    If the enclosure is lifted or moved with the equipment installed, the brief says so, and the drawing marks the lifting points the reply agreed.

Related services

The kinds of work that cover this sector.

All services

Each one has its own page with the full scope, the files and what it does not promise.

Other sectors

The other sectors the office draws for.

All sectors

Contact

How to reach the office.

For a job, use the enquiry form: it sends your drawings and models with the request. For anything else, write to one of the two addresses.

Sales and general enquiries
[email protected]
Direct contact
[email protected]

06 / Quote

Name the sector in the enquiry.

Say which sector the job belongs to, what should be drawn and which files you already have. A person reads it and replies by email to the address you type.