01 / ServicesStudio model, not a job

Special container design and drawings

Construction design of a container or a container-sized module: what changes in the volume, where the openings are, and how a cut returns to the frame.

01 / 03

What is drawn

A general arrangement with the long side, the door end, a plan and a section. Dimensions start from one origin, so openings are not each measured from a different corner.

Trim and reinforcement around a cut. Partitions and the floor, when they are in the brief, and how they meet the existing frame. A note of what on the original module stays.

Drag sideways to turn the model

  1. Corner post and rail frameStudio model, not a job
  2. Long wallStudio model, not a job
  3. End walls and far wallStudio model, not a job
  4. RoofStudio model, not a job
  5. Trim around the openingStudio model, not a job

02 / 03

Which files come out of it

A PDF to read. A DXF at 1:1 where plate or profile will be cut. A STEP file when the solid is part of the delivery. A DWG if the drawing will be edited further. The exact list is in the reply, not fixed in advance on this page.

03 / 03

What this page does not promise

Ferrota does not sell container manufacture here, and it does not publish a price. A drawing is not a statement that the module already stands in a hall. If a structural check is part of the scope, the reply says so.

Quote

Write what should be drawn.

The reply comes to the email you type here. This page does not send you a confirmation email. You will not get a price or a lead time from the form.