04 / IndustriesStudio model, not a job

Logistics and storage

Storage and handling equipment is made of the same part again and again: a rack bay, a cage panel, a door in a long side. The drawing is read many times, so a part is drawn once, with its quantity, and every sheet agrees with the parts list.

01 / 03

What is drawn for storage and handling

Storage containers with a door or a roller opening in the long side, and the trim around it. Racks, cages and frames, drawn as an arrangement first, then the repeated parts on their own sheets.

Forklift pockets, lifting points and stacking corners, when the brief asks for them, placed from the same origin as everything else on the sheet.

Drag sideways to turn the model

  1. Column on a base plateStudio model, not a job
  2. Main beamStudio model, not a job
  3. Secondary beamStudio model, not a job
  4. Grating deckStudio model, not a job
  5. HandrailStudio model, not a job

02 / 03

Which files come out of it

A PDF set with a parts list: each repeated part has one mark, one sheet and a quantity. A DXF at 1:1 for the cut parts, one file per part, named after its mark. A STEP file of an assembly when the solid is part of the delivery. The reply confirms the list.

03 / 03

What this page does not promise

This page does not promise a rack load rating, the planning of a warehouse layout or the supply of storage systems. The load per level and the rules a rack must meet are named in the brief. A drawing is not a statement that the series has been made.

Quote

Drawn for your job, not for a sector.

The sector only sets the questions. Describe your object, its limits and the files you have, and the reply names what will be drawn, in which files, and what is not in the job.

What matters hereLogistics and storage

What a set for this sector has to resolve.

The questions a drawing set in this sector usually has to answer before anything is cut. The enquiry does not need every answer; the reply asks for what is missing.

  1. 01

    One part, one mark, one quantity

    A part that repeats is drawn once and carries its quantity. A second, slightly different drawing of the same part is exactly how a series goes wrong.

  2. 02

    A parts list that matches the sheets

    The parts list, the sheet numbers and the DXF file names use the same marks, so a cut list can be read without the person who drew it.

  3. 03

    Large openings in a long side

    A door in the long side of a storage container takes away much of the wall. The trim and the reinforcement that keep the container true are part of the drawing.

  4. 04

    Handling points from the brief

    Forklift pockets, lifting points and stacking corners are drawn where the brief puts them, and the brief names what will lift or stack the unit.

Related services

The kinds of work that cover this sector.

All services

Each one has its own page with the full scope, the files and what it does not promise.

Other sectors

The other sectors the office draws for.

All sectors

Contact

How to reach the office.

For a job, use the enquiry form: it sends your drawings and models with the request. For anything else, write to one of the two addresses.

Sales and general enquiries
[email protected]
Direct contact
[email protected]

06 / Quote

Name the sector in the enquiry.

Say which sector the job belongs to, what should be drawn and which files you already have. A person reads it and replies by email to the address you type.