05 / IndustriesStudio model, not a job

Public and event structures

Kiosks, pavilions, stages, stands and shelters, often made from containers or bolted steel frames. Many of them are assembled, taken apart and assembled again, so the drawing is used on site more than in the workshop.

01 / 03

What is drawn for a kiosk, a pavilion or a stage

The arrangement of the structure on its site, with the openings, the counters or the access the brief describes. A container conversion gets the same general arrangement as any module; a steel frame gets member marks and joints.

An assembly drawing that shows the order in which the parts go up and come down, with the site joints drawn as bolted where the structure has to come apart again.

Drag sideways to turn the model

  1. Column on a base plateStudio model, not a job
  2. Main beamStudio model, not a job
  3. Secondary beamStudio model, not a job
  4. Grating deckStudio model, not a job
  5. HandrailStudio model, not a job

02 / 03

Which files come out of it

A PDF of the arrangement and of the assembly sequence, readable on site. A DXF at 1:1 for the cut parts. A STEP file when the designer of the fit-out or the graphics needs the solid. The reply names which of these the job needs.

03 / 03

What this page does not promise

This page does not promise a permit, a structural approval, a crowd or wind load rating, or a safety sign-off for an event. The rules the structure must meet and the loads it must carry are named in the brief. If a structural check is part of the job, the reply says so.

Quote

Drawn for your job, not for a sector.

The sector only sets the questions. Describe your object, its limits and the files you have, and the reply names what will be drawn, in which files, and what is not in the job.

What matters herePublic and event structures

What a set for this sector has to resolve.

The questions a drawing set in this sector usually has to answer before anything is cut. The enquiry does not need every answer; the reply asks for what is missing.

  1. 01

    Up, down and up again

    If the structure is used again, the order of assembly and dismantling is on the drawing, and the joints that open are bolted, not welded.

  2. 02

    Parts sized for the journey

    Every part has to fit the vehicle and suit the hands or the crane that will move it. The split into parts is decided on the drawing.

  3. 03

    Marks that last a season

    The drawing gives every part a code that the steel carries too, so the structure goes back together the same way after storage.

  4. 04

    A replacement made to the drawing

    A bent member is replaced by one made to the current revision, not copied from the damaged piece. The title block says which revision that is.

Related services

The kinds of work that cover this sector.

All services

Each one has its own page with the full scope, the files and what it does not promise.

Other sectors

The other sectors the office draws for.

All sectors

Contact

How to reach the office.

For a job, use the enquiry form: it sends your drawings and models with the request. For anything else, write to one of the two addresses.

Sales and general enquiries
[email protected]
Direct contact
[email protected]

06 / Quote

Name the sector in the enquiry.

Say which sector the job belongs to, what should be drawn and which files you already have. A person reads it and replies by email to the address you type.