01 / IndustriesStudio model, not a job

Site and welfare modules

A container-sized module for a site office, a changing room or a welfare unit. Whether it is new or a converted container, the drawing settles what is cut out, what is added inside and how one module meets the next.

01 / 03

What is drawn for a site module

A general arrangement of the module: the long side, the door end, a plan and a section, all dimensioned from one origin. Doors and windows are placed on it before anything is cut.

Trim and reinforcement around each opening, partitions and the floor build-up when they are in the brief, and the points where pipes and cables pass through a wall or the floor. Where modules stand side by side or on top of each other, the joints between them are drawn too.

Drag sideways to turn the model

  1. Corner post and rail frameStudio model, not a job
  2. Long wallStudio model, not a job
  3. End walls and far wallStudio model, not a job
  4. RoofStudio model, not a job
  5. Trim around the openingStudio model, not a job

02 / 03

Which files come out of it

A PDF of the arrangement for the people who approve the layout. A DXF at 1:1 for the trims and plates that are cut. A STEP file when the module goes on to another designer, for example for the pipework and wiring. The reply lists the files; this page does not fix them.

03 / 03

What this page does not promise

This page does not promise the design of the plumbing, wiring or heating inside the module, a building permit, or a module for sale or hire. A fire rating or an insulation value is a requirement the brief names; this page states no figure. If a structural check is part of the job, the reply says so.

Quote

Drawn for your job, not for a sector.

The sector only sets the questions. Describe your object, its limits and the files you have, and the reply names what will be drawn, in which files, and what is not in the job.

What matters hereSite and welfare modules

What a set for this sector has to resolve.

The questions a drawing set in this sector usually has to answer before anything is cut. The enquiry does not need every answer; the reply asks for what is missing.

  1. 01

    Where an opening cuts the frame

    A door or a window in the long side interrupts the wall and sometimes a rail. The drawing shows the cut, the trim that closes it and the reinforcement around it.

  2. 02

    Partitions against the frame

    Internal walls are placed from the same origin as the openings, so a partition never lands in front of a window. Where it meets the frame is a detail, not a note.

  3. 03

    Penetrations for pipes and cables

    Water, waste and cables pass through the floor or a wall at points someone has to fix. The set marks them, so the steel is not cut twice.

  4. 04

    How modules meet

    When modules stand side by side or are stacked, the joint, the seal line and the order of placing are on the arrangement, not left to the site.

Related services

The kinds of work that cover this sector.

All services

Each one has its own page with the full scope, the files and what it does not promise.

Other sectors

The other sectors the office draws for.

All sectors

Contact

How to reach the office.

For a job, use the enquiry form: it sends your drawings and models with the request. For anything else, write to one of the two addresses.

Sales and general enquiries
[email protected]
Direct contact
[email protected]

06 / Quote

Name the sector in the enquiry.

Say which sector the job belongs to, what should be drawn and which files you already have. A person reads it and replies by email to the address you type.