Journal
Tolerances and title blocks on a workshop drawing
A dimension without a tolerance is an incomplete requirement. The shop then applies its own habit, and two shops may not apply the same one. A sheet therefore carries one general tolerance note, and a special tolerance only where the limit is tighter or looser than that general rule.
One note, not a number on every dimension
The general tolerance is stated once, as a reference to an agreed class or as a small table in millimetres. It does not need to be repeated on every size. A size that controls a fit, an opening, or a joint with someone else's part gets its own tolerance on that dimension. In the enquiry it is enough to say which class your fabricator expects. If you do not say, it belongs among the questions in the reply, not in a silent assumption.
The title block
- A drawing title that says what is on the sheet, not an internal code with no words.
- A drawing number and a revision. The numbering is agreed. It is not copied from someone else's archive without permission.
- Scale, units, and how many sheets are in the set.
- The date of the issue, and a short description of the change at every revision.
- The name of the person who drew it, and of the person who checked it, when those roles exist on the job.
The unit of this kind of steel documentation is the millimetre, unless the sheet says otherwise. A revision is a letter or a number, a date, and a sentence about what changed. A first issue is often 0 or A. If the fabricator expects a different sequence, that belongs in the enquiry.
The title block does not belong in a cutting DXF. It belongs on the drawing that is read, and on the PDF that is issued.
Related