Journal

What drawings a container conversion needs

A container conversion, or the design of a container-sized module, changes a finished steel volume: new openings, partitions, a floor, and reinforcement where the original wall is cut. The documentation has to show those changes so they can be made, and so it is clear what remains of the original module.

The general arrangement

The first sheet shows the whole. The external outline, the door end, the long side, a plan, and at least one section. It should be obvious where dimensions start. Later openings are then located from that same point, not each from a different corner.

Openings and reinforcement

Every opening needs a width, a height, a position, and a note of what surrounds it. A door needs the hinge side and the threshold. A window needs its seating. A cut in a container wall removes a sheet panel and often part of the frame, so the drawing has to show how the opening is trimmed. A plan without a section cannot do that.

  • An opening schedule: mark, size, position from the stated corner, and the infill type.
  • A drawing of the trim and the reinforcement around the cut.
  • A plan of partitions and the floor, if they are in the brief, with how they meet the frame.
  • A note of what on the original module does not change.

Files, not only paper

A PDF is the sheet a person reads. A DXF at 1:1 is the geometry for cutting plate and profile. A STEP file is the solid, when the fabricator needs to understand the weldment as a model. The title block, the revision and the dimensions live on the drawing. They are not in the STEP file. A set that is only a model is not yet production documentation.

A conversion drawing is not a statement that the module has been built, and it does not replace a structural check when the brief needs one. A calculation is a separate part of the scope and belongs in the reply.

Related

06 / Quote

Describe your own job in an enquiry.

The journal explains the principle. The reply to an enquiry applies it to your object, its limits and the files you have, and names the scope.